Norton 5930 Stop Push Side Of Door Low Energy Door Operator

• Ease of installation and setup
- Simple instructions
- "One touch" programming
• Application versatility and ease of adjustment
- Non-handed units
- Push-side mounting
- Interfaces with electric hardware
- Integrates with access control system
• Operation startup options
- Wall switches
- Motion sensor
- Radio frequency device
- Push and Go
• Presence Detector input
• Sync cable for double doors; synchronizes closing of two operators
• Finishes Aluminum 689 and Statuary Bronze 690

Functions

• Power Assist
– When unit is activated, it allows the door to be opened manually with a force less than 5 lbs.
• Push and Go (selectable)
– As the door is manually opened, the operator “senses” movement and opens door to the full-open position.
• Obstruction Detection
– Open: Door closes if it hits an obstruction while opening
– Close (Stop on Stall): Door will stop once it hits an obstruction and rest against the obstruction until obstruction is removed
• Motor Startup Delay
– Delays operator opening
• Infinite Hold Open
– Door will hold open at set position until power is turned off
• Power Latch (selectable)
– Increases latch power
• Selector mode switch (3 position)
– Off - Disables signal inputs
– On - Activates signal inputs
– Hold Open - Activates the unit to the hold open position

Electrical Data

• Power input 120 VAC, 60 Hz (+10%, -15%)
• Current draw .75A
• 12VDC @ .5A output, 24VDC @ .25A output, 24VDC @ .4A output

Mounting Applications

• 5930 Stop (Push) Side of Door Standard-Duty Double Lever Arm
• Frame reveals 2-3/4" to 5-3/4" (70 to 146mm)
• An auxiliary door stop is required for these applications