• Built-in stops in the rose insert prevent lever from traveling beyond approximately 57 degrees.
• Q Series levers employ the unique flex-adapter which allows thru-bolting installation with pre-existing holes or new installation where conditions allow thru-bolting at any location.
• Lever design: Sierra Handle
• Finishes: 612 US10 10 Satin Bronze and 626 US26D 26D Satin Chromium Plated
|Manufacturer||Arrow Lock And Door Hardware|
|Lock Functions||Q07 - Exit - Latchbolt operated by inside lever only. Outside lever always rigid.|
|Door Thickness||1-3/4" (44.45 mm) standard|
|Backset||2-3/4" (69.85 mm) backset standard|
|Case||Cold rolled steel with zinc dichromate finish for corrosion resistance. Latch retractor is precision zinc die cast. Requires standard 2-1/8" (53.97 mm) bore through door|
|Latchbolt||Brass with 1/2" (12.7mm) throw standard. 3/4" (19.05mm) throw deadlocking firelatch is available for pairs of doors. Latch housing is steel, zinc dichromate finish for corrosion resistance. 1" (25.4mm) bore in edge of door is required.|
|Exposed Trim||Levers are pressure cast zinc. Streamline rose scalp of brass or bronze complements other series of lever locks|
|Roses||Contain coil spring which is a permanent assembly within rose insert. The inside insert has graduating steps in two locations to prevent rose scalp from loosening. A “catch” on the outside insert prevents rose scalp from working itself loose during installation.|
|Strikes||Brass, bronze or stainless steel. ANSI A115.2, 4-7/8" (123.82 mm) x 1-1/4" (31.75 mm) curved lip|
|Certifications||ANSI/BHMA A156.2, Series 4000, Grade 1|
|U.L. Listed||Underwriters Laboratories (UL and CUL) listed for use on 3 hour, A label single swinging doors.
Federal Specification FF-H-106C
ANSI A117.1 Accessibility Code
California State Reference Code–for levers returning to within 1/2" (12.7mm) of door surface.
|Warranty||Limited three year warranty|
Write Your Own Review
Questions on Arrow Q07SR Exit Cylindrical Lever Lock Non-Keyed
No questions asked yet